Advertisement
SELECT PROGRAMME
Press the programme selection button until the required programme appears (Table 1.1, Page 5). The
appliance will switch on automatically. If required, select options (if supplied). These are saved at the end
of the cycle even if another programme is selected. The corresponding indicator lamp lights up.
WASH CYCLE
The dishwasher door must be closed and the
water tap open.
To load crockery, open the door carefully (the
Start indicator lamp will flash and a beep will
sound):
Beware of hot steam!
Press the Start button again. The programme resumes from where it was interrupted, with the door
closed.
The wash cycle can be interrupted at any time by pressing Cancel/Off button. The appliance drains
water for about 60 seconds (with the door closed) then switches off automatically.
END OF PROGRAMME
Open the door carefully only after all the lights have switched off and a beep has sounded: hot steam
may escape! Unload the appliance, starting from the lower rack in order to avoid any residual drips of
water falling onto crockery below.
For even better drying results, leave the dishwasher door open a little before unloading in order to
allow the steam to dissipate, helping the dishes to dry. The underside of the kitchen worktop must
be protected (see instructions in "Maintenance and Installation").
Changing the programme in progress/RESET
- Press the Cancel/Off button.
- Water drains automatically for up to 60 seconds with the door
closed.
- Select the programme and press the Start button.
12
Advertisement
