Samsung WW6 R2 Series User Manual page 35

01 Cycle Selector
02 Display
03 Temp.
04 Spin
05 Options
06 Delay End
07 Bubble Soak
08 Soak
09 Power
Untitled-2 35
Turn the dial to select a cycle.
The display shows current cycle information and estimated time
remaining, or an information code when a problem occurs.
Press to change the water temperature for the current cycle.
Press to change the spinning speed for the current cycle. The
revolutions per minute (RPM) differs with the model.
• Rinse Hold : The final rinse process is suspended so that the
laundry remains in the water. To unload the laundry, run a
drain or spin process.
• No Spin : The drum does not rotate after the final drain
process.
• Spin Only : To run the Spin Only cycle, press Spin for 3
seconds. When the cycle time and spinning speed appear,
press Spin repeatedly until a desired spinning speed is
selected. Then, press Start/Pause to start the cycle. The
spinning time depends on the selected cycle.
Press to select an option from Intensive, and Pre Wash. Press
again to deselect.
• Availability of the options depends on the cycle.
Delay End lets you set the end time of the current cycle. Based
on your settings, the start time of the cycle will be determined
by the machine's internal logic. For example, this setting is useful
for programming your machine to finish a wash at the time you
normally return home from work.
• Press to choose a preset unit of hours.
Bubble Soak helps remove a variety of stubborn stains.
• With Bubble Soak selected, laundry is thoroughly soaked in
water bubbles for effective washing.
• Bubble Soak adds up to 30 minutes to the selected cycle.
• Availability of this option depends on the cycle.
Press to activate/deactivate the Soak function. This function
helps remove a wide variety of stubborn stains.
Press to turn on/off the washing machine.
English 35
2019-05-29 7:19:06