Electrical Data - Panasonic CW-C50GU Installation And Operating Instructions Manual

b. While steadying the air conditioner, carefully bring
the window sash down behind the upper guide of the
air conditioner, as shown in Fig. 11.
4. SECURE THE GUIDE PANELS
Extend the guide panels (TYPE F) to fill the window
opening using 4 screws (TYPE B) to secure them, as
shown in Fig. 12.
5. INSTALL THE SASH SEAL AND SASH LOCK
a. Cut the sash seal (TYPE E) to the window width.
Stuff the sash seal between the glass and the
window to prevent air and insects from getting into
the room, as shown in Fig. 12.
b. Fasten the "L" bracket using a (TYPE A) screw, as
shown in Fig. 12.
6. Window installation of room air conditioner is now
completed. See ELECTRICAL DATA for attaching
power cord to electrical outlet.
C. HOW TO SECURE THE DRAIN PIPE
In humid weather, excess water may cause the BASE
PAN to overflow. To drain the water, remove the
DRAIN CAP and secure the DRAIN PIPE to the rear
hole of the BASE PAN. (Fig. 13)
REMOVAL FROM WINDOW
Turn the air conditioner off, disconnect the power cord, remove the "L" bracket and the screws installed
through the top and bottom of the guide panels, and save for reinstallation later. Close the guide panels.
Keeping a firm grip on the air conditioner, raise the sash, and carefully tilt the air conditioner backward,
draining any condensate water. Lift the air conditioner from the window and remove the sash seal from
between the windows.

Electrical Data

Line Cord Plug
Do not under any
circumstances cut
or remove the
grounding prong
from the plug.
Power supply cord with
3-prong grounding plug
USE OF EXTENSION CORDS
Because of potential safety hazards, we strongly discourage the use of an extension cord. However, if you wish to
use an extension cord, use a CSA certified/UL-listed 3-wire (grounding) extension cord, rated 15A, 125V.
WINDOW FRAME
UPPER GUIDE
BOTTOM
GUIDE
Fig. 11
"L" BRACKET
TYPE A
TYPE B
Fig. 12
Fig. 13
Use Wall Receptacle
Standard 125V, 3-wire grounding
receptacle rated 15A, 125V AC
10
SEAL
"L" BRACKET
hang
DRAIN CAP
DRAIN PIPE
Power Supply
Use 15 AMP time
delay fuse or circuit
breaker.
ABOUT 1/4"
SASH SEAL
(TYPE E)
push