Table of Contents
Advertisement
English
Hang Hook (Fig. 1)
WARNING: To reduce the risk of injury
from the threaded rod cutter falling on
operators or bystanders, make sure it
is supported securely when using the
hang hook, or resting in a secure and
stable location when not in use. Be sure
to keep the area below clear to reduce
the risk of the tool or off-cut material
falling and striking someone or something
below.
The threaded rod cutter has a convenient hang
hook (F) that allows it to hang on a suitable, stable
structure between uses.
Cutting (Fig. 7)
WARNING: Cut Hazard. Wear gloves
when handling threaded rod. The
edges are sharp and can cause serious
personal injury.
CAUTION: Cut length of threaded rod
to be 6mm (1/4") minimum.
For accurate work, always secure the workpiece
before cutting.
NOTICE: Before cutting, make sure the correct die
size is in place for the intended size rod.
1. Position the threaded rod so that the material
is between the stationary cutting die (C) and
moving cutting die (D).
2. Align the threaded rod with cutting dies.
3. Depress trigger until the workpiece is fully cut.
4. Release trigger when the cutter has reached
the open position.
When cutting overhead, always confirm workpiece
is secure before cutting and be sure the excess rod
that is cut is disposed of safely.
MAINTENANCE
Your D
WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular
cleaning.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up can
cause injury.
The charger and battery pack are not serviceable.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
Optional Accessories
WARNING: Since accessories, other
than those offered by D
been tested with this product, use of
such accessories with this tool could be
hazardous. To reduce the risk of injury,
only D
WALT recommended accessories
e
should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.
WALT, have not
e
Advertisement
Table of Contents
