Table of Contents
Advertisement
Malfunction
Creasing.
Detergent or fabric softener
softer drips from
the cuff and collects on
the door or in the cuff
crease.
Centrifuge result is
not satisfied-
ity. The laundry is too
wet / too damp.
Cause and Troubleshooting
Spin speed is too high.
Set a lower spin speed for the next wash.
▶
The load amount is too high.
Reduce the load amount for the next wash.
▶
Unsuitable program for the type of fabric set.
Choose a suitable program for the type of fabric.
▶
Too much detergent/fabric softener in the detergent
drawer.
When dosing the liquid detergent and fabric
▶
softener, pay attention to the marking in the
detergent drawer and do not exceed it.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
Launch the programCentral / Essay.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
trapped.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or trapped.
The imbalance detection system has stopped the spin
cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
Launch the programCentral / Essay.
▶
Imbalance control system compensates for
imbalance by reduced spin speed.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
Launch the programCentral / Essay.
▶
TroubleshootingNL
53
Advertisement
Table of Contents
