Table of Contents
Advertisement
4.
When no more clippings come out, stop the
water and move the machine to a dry area.
5.
Start the engine and run it for a few minutes to
dry the underside of the machine to prevent it
from rusting.
6.
Shut off the engine, remove the electric-start
button (if equipped), and allow the machine to
cool before storing it in an enclosed area.
Folding the Handle
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1.
Remove and save the 2 handle knobs and 2
carriage bolts from the handle brackets
16).
Important:
Route the cables to the outside
of the handle knobs as you fold the handle.
1. Handle knob
2.
Fold the handle by rotating it forward
1. Operating position
Figure 16
2. Carriage bolt
(Figure
Figure 17
2. Folded position
3.
Insert the carriage bolt (with the bolt head toward
the inside) through the handle bracket and the
upper hole in the handle end. Ensure that the
square edges of each carriage bolt fits into the
upper or lower square hole in its related handle
bracket
1. Handle knob
4.
Loosely install the handle knobs and carriage
bolts on the handle brackets.
(Figure
5.
To unfold the handle, refer to
Unfolding the Handle (page
g189871
17).
g360887
16
(Figure
18).
Figure 18
2. Carriage bolt
1 Assembling and
4).
g189864
Advertisement
Table of Contents
