Putting On The Heart Rate Monitor - Mio Cyclo 215HC User Manual

c
b
2. Ensure that the magnets are aligned with the sensing area on the sensors.
3. When done, you can manually pair the sensor with your device by tapping
Main menu > Settings > Sensors > Cadence/Speed.
The cadence sensor contains a replaceable CR2032 battery. Follow the
instructions below to replace the battery:
a
d
7
1. Locate the battery cover on the back of the sensor, and then twist the cover
anticlockwise (e.g. by using a coin) to remove the cover and battery.
2. Insert the new battery into the battery chamber and replace the cover.
3. Twist the cover clockwise (e.g. by using a coin) to close the cover.

Putting on the heart rate monitor

Note: Please note the heart rate monitor is not a medical device and its readings are not
a substitute for obtaining measurements that require medical precision. It is strongly
recommended to consult a doctor if you have a pacemaker or other implemented devices
before using the heart rate monitor.
1. Before using the heart rate monitor, wet the contacts on the back of the
chest strap.
Note: If possible, you can also use an electrolyte gel (usually available in local sports
stores) to ensure good contact.
2. Adjust the elastic strap so it's snug while you are putting it on. Ensure that
you can take a good deep breath after putting on the strap.
3. Follow the instructions below to wrap the strap around your back, and then
secure it on the other side with the buckle.
Putting on the heart rate monitor is like wearing a belt around your lower
chest.