Power Stabilizing Jacks; Power Jack; Power Jack Fuse; Hitch/Coupler - Airstream TOMMY BAHAMA 2017 Owner's Manual

Hide thumbs Also See for TOMMY BAHAMA 2017:
Table of Contents

Advertisement

Exterior

Power Stabilizing Jacks

The Tommy Bahama trailer is equipped with two sets of
power stabilizing jacks� These jacks are controlled by a
switch located in the locked utility compartment on the
side of the trailer�
NOTE
Power stabilizing jacks automatically adjust to the
terrain and should only be lowered until they make
contact with the ground.
CAUTION
Stabilizing jacks are designed to stabilize the
trailer only. Misuse of the power jacks to level or
lift the trailer will result in damage to the jacks and
potentially the trailer.

Power Jack

A switch located on the bottom of the housing operates
the power jack� When the jack is fully extended or
retracted, internal limit switches automatically shut off
the motor�
The jack is wired directly to the battery and has an in-
line fuse between the battery and the power head�
• Use the jack for lifting the trailer only�
• Never get beneath the travel trailer when only the
power jack supports it�
• Support the vehicle by appropriate means�
Avoid the risk of injury to yourself and others.
Keep hands and feet from under the foot plate
when using the jack.
Do not use or install dolly wheels on the power
jack. Failure to comply could result in serious
injury
6-6
WARNING
WARNING
WARNING

Power Jack Fuse

Should an electrical failure occur, first check to make
sure the fuse is not blown� If the fuse is not blown
place manual override handle into alignment tube and
engage drive pin� Rotate handle counterclockwise to
raise or clockwise to lower the camper�
Refer to the Maintenance section for replacement and
maintenance of the power head�

Hitch/Coupler

1� Open Position
2� Padlock Insert Hole
3� Closed Position

Operating Instructions

1� To open - slide forward and pull up to open latch
before inserting ball�
2� Place coupler on ball of same diameter as coupler
and of same or greater capacity�
3� When ball is completely nested in socket, push
top of latch handle rearward until handle snaps
into closed position� Extend jack to ground and lift
tow vehicle/trailer combination 2 to 4 in� to ensure
coupler is securely attached to tow ball� Retract
jack before towing�
4� Insert padlock through hole in handle for theft-
prevention purposes�
Always open latch handle before inserting ball into
coupler.
2017 Tommy Bahama TT
WARNING

Advertisement

Table of Contents
loading

Table of Contents