Advertisement
1) Remove the tweeter's plastic
TWEETER
SURFACE
MOUNTING
2) Mark the location in which you are
3) Mount the backplate with the two
4) Feed the wires through the holes
TWEETER
1) Remove and discard the tweeter's plastic
ANGLE
MOUNTING
2) Drill out the appropriate holes in the back of
3) Mount the angle mount backplate with the two
4) Feed the wires through the holes and attach
backplate by separating the plate
from the tweeter housing with your
two thumb nails at one of the
terminal locations, gently prying the
two pieces until they snap apart.
See Figure 3.
going to mount the tweeter using
the supplied template and drill holes
for each of the two wires. Also drill
small "pilot" holes for the two
mounting screws.
1/2" flat head screws. See Figure 4
below.
and attach them to the speaker
wires going to the crossover.
Position the tweeter over the
backplate and then simply snap it
back on. Be sure to feed the Red
wire through the (+) marked hole.
backplate as described above.
the angle mount. Mark the location in which
you are going to mount the tweeter using the
supplied template and drill holes for each of
the two wires. Also drill small "pilot" holes for
the two mounting screws.
1/2" flat head screws. See Figure 5.
them to the speaker wires going to the
crossover. Position the tweeter over the
backplate and then simply snap it back on.
5
FIGURE 3
FIGURE 4
1/2" Flat Head
Screws
FIGURE 5
Advertisement
