LG WT7300CW/00 Owner's Manual page 32

32 TROUBLESHOOTING
Problem Possible Cause
Lid (Door) is not closed properly.
Lid (Door) lock switch error.
Foreign objects such as coins, pins,
clips, etc., caught between the wash
plate and the inner basket.
It is time to run the Tub Clean cycle.
The washer has detected an out of
balance load.
Control error.
Water level is too high due to a
faulty water valve.
The water level sensor is not
working correctly.
A motor error has occurred.
Clutch error
Solutions
• Close the lid (door) and press Start/Pause
button. After starting a cycle, it may take a few
moments before the tub begins to turn or spin.
The washer will not spin unless the lid (door) is
locked.
• If the error persists once the lid (door) is closed
and the Start/Pause button is pressed, call for
service.
• Make sure that the lid (door) is closed properly
and press the Start/Pause button. The washer
will not operate unless the lid (door) is locked.
• Make sure that nothing is caught under the lid
(door), including shipping material or clothing.
• Make sure that the latch mechanism is fully
retracted.
• If the lid (door) is closed and the lid (door) lock
error message is displayed, call for service.
• Turn the washer off then on again. Press the Spin
button without selecting a cycle to drain and spin
the load.
• When the Spin cycle is complete, empty the tub
and find and remove any objects caught in the
wash plate.
• Always check pockets, etc., before washing to
prevent error codes or damage to the washer or
clothing.
• Run the Tub Clean cycle.
• If the washer detects a load that is too far out of
balance to spin, it will display this code while it
is attempting to rebalance the load. The washer
will add water and try to redistribute the load
automatically. This display is for your information
only, and no action is required.
• As a result, the cycle will take longer than initially
estimated.
• Unplug the washer and wait 60 seconds.
Reconnect power and try again. If the error
reappears, call for service.
• Close the water faucets, unplug the washer, and
call for service.
• Close the water faucets, unplug the washer, and
call for service.
• Allow the washer to stand for 30 minutes and
then restart the cycle. If the LE error code
persists, call for service.
• Mechanical failure
• Unplug the washer and call for service.