Advertisement
* RS-232C Command
- LA75C Chassis Model All
RS-232C COMMAND
[CMD ID DATA]
Cool
Mid
Warm
R Gain
jg
ja
G Gain
jh
jb
B Gain
ji
jc
R Cut
G Cut
B Cut
7-4. White Balance Adjustment(Manual)
(1) Test Equipment: CA-210
(2) Manual adjustment sequence is like bellowed one.
1)Turn to "Ez-Adjust" mode with press ADJ button of
service remocon.
2) Select "9.Test Pattern" with CH+/- button and press
enter. Then set will go on Heat-run mode. Over 30
minutes set let on Heat-run mode.
3) Let CA-210 to zero calibration and must has gap more
10cm from center of LCD module when adjustment.
4) Press "ADJ" button of service remocon and select
"6.White-Balance" in "Ez-Adjust" then press "
of navigation key. (When press "
go to full white mode)
5) Adjust at three mode (Cool, Medium, Warm)
- When R Gain is fixed at 192
: Control G Gain and B Gain by reducing them from 192.
- When B Gain is fixed at 192,
: Control R Gain and G Gain by reducing them from 192.
- When G Gain is fixed to 192,
: Control R Gain and B Gain by reducing them from 192.
Fix one of three Gains (R Gain, G Gain, and B Gain) at 192
and control the other two by reducing values from 192 to
prevent it from increasing.
(When RGB Gains are all 192, the module is in full dynamic
range.)
(Automatic Adjustment)
CENTER
(DEFAULT)(Decimal)
Min
Cool
Mid
jd
00
je
00
jf
00
64
64
64
64
64
64
G
" button then set will
Max
(Deci
mal)
Warm
192
192
192
64
64
64
G
" button
Advertisement
