ZION CARBON Operation Manual page 10

INSTALLATION GUIDE
5. Align the backboard (section 8) with bottom board's corresponding battens;
make sure they are in line. See FIG-4
6. Align the right board (section 7) with bottom board's corresponding battens;
make sure right board fits flush into backboard. See FIG-4
FIG-5 (Combination to assembly) Buckle
7. The latch has a guide tab that must be placed in the guide slot for alignment. Pick
up the back panel (hold it upright to the floor panel) and place the tab in the slot,
do not latch at this time. When the back wall and the front wall/side wall are set
together on the floor panel, close and pin the latches. See Figure 5
8. Put the sitting board (section 6) horizontally on corresponding battens of the
backboard. See FIG-6
9. Locate bench wall with heating element (section 5) and slide it down vertically
into the slot within the inside wall. Next, connect the bench's heater element wire to
corresponding wire from the back wall, then locate sitting baffle (section 5 and
slide into place. See Figure6, 7, 8 Note: Make sure the wires are tightly connected,
otherwise the heater will not work.
11