Uni-bond E-2111AC-M User Manual

Last Updated: 09/12/2023
USER MANUAL
E-2111AC-M
Part No.
Mounting (Single Bolt)
Step 1
Remove the 4 screws on the
mounting plate in the centre
Flash Patterns
**Rotating Flash: switching between CW & CCW
Press [ ] button 5 times in quick succession
Flash Pattern
NO.
1 6-Flash
2 Double Flash
3 Single Flash - SAE Class 1
4 Mega Flash
5 Rotating Flash (Quick)**
6 Alternating Left & Right Mega Flash
7 Alternating Left & Right Single Flash
8 Rotating Flash (Slow)**
9 Alternating Diagonal 6-Flash
10 Alternating Diagonal Double Flash
11 Random
Step 2
Flash Patterns
Note : Disassembling lamp will void the warranty
WARNING:
It is not recommended to use magnetically mounted warning devices on outside of vehicle in motion.
Usage is at the sole risk and responsibility of the user.
DO NOT use a high pressure power washer to clean your E-2111AC-M, this may damage your E-2111AC-M and void
its warranty.
For more information, visit our website at: www.unibondlighting.com
Remove the mounting plate
Insert the hex bolt in place
Wiring Information
**Note: This info is only for hardwire option. User/Installer is
responsible for any damages done when deciding to remove
the cigarette adapter in order to expose individual wires.
Wire Colour
Red
White
Brown
Light should be fused with 5 Amp Fuse (
Suggested Switch Connection
Battery Ground
Ground
Power
Pattern Selection
ON/OFF Switch
Flash Pattern Button
Momentarily press the button
- Once to the next pattern
- Three times in quick succession for
Flash Pattern NO. 1
Step 3
Insert the mounting plate on top
Mount in place with the 4 screws
Function Connect To
Power +12/24 VDC (Power)
-
Ground (Ground)
Pattern Selection
+12/24 VDC (Power)
ATM05 sold separately
(switches sold separately)
From Battery Positive
Flash Pattern button
ON/OFF button
)
Jumper Wires
Switch #1
ST307
(OFF-ON-Momentary ON)