Titan Commercial Grade LED Display Installation Guide
Part 1: Display Mounting
Step 1
Install 'Ram mount' bracket on rear of
display using the four VESA mount
PEMS.
Step 2
Attach 'Ram mount' arm to bracket by
unscrewing the giant wing-nut and plac-
ing over pedestal ball.
Part 2: Connecting the Display to Power
Step 1
Connect input voltage wires (1) from vessels power supply (i.e. 12, 24, 36 VDC or 110 VAC as specified on order) to Nauticomp
power supply. Connect
red
securely.
Step 2
Connect the wires (2) from the display to the power supply. Connect red wire to positive output terminal and the black wire to
1
Part 3: Connecting Cables to the Display
POWER OUTPUT FROM THE PROVIDED NAUTICOMP POWER SUPPLY IS TO BE 12.1VDC. PLEASE DOUBLE CHECK BEFORE
CONNECTING TO THE DISPLAY FOR THE FIRST TIME.
PLEASE NOTE: ALWAYS CONNECT ALL VIDEO INPUT CABLES BEFORE CONNECTING THE POWER
Step 1
Press in Power connector until secure, Press in DVI, VGA, S-Video & Composite connectors then screw in mounting screws.
Step 2
Gently pull all cables to insure that they are connected securely.
POWER
DVI
See reverse for Quick Reference
Pedestal Mount
wire to positive input terminal and the black wire to negative input terminal. Tighten connectors
3
2
VGA
Bracket Mount
Step 1
Attach Mounting Brackets to display
using the 4 supplied screws.
Step 2
Mount display to dash as desired.
S-VIDEO
COMPOSITE
AUDIO