Table of Contents OVERVIEW How It Works PRODUCT CONTENTS BABY BEAR SPECIFICATIONS INSTALLATION 1. Determine Location of Install 2. Remove the Baby Bear from Packaging and Assemble 3. Connect to Pool and Start-up OPERATION WINTERIZATION WARRANTY 10140...
Overview Thank you for choosing FAFCO for your swimming pool solar heating solution. This solar collector is proudly manufactured in the United States. Since 1969, we have provided high-quality, long-lasting products that help our customers save money on energy costs and reduce the environmental impact associated with traditional pool heating.
The maximum flow of the Baby Bear should not exceed 30 gpm per panel. Water flows through the filter and back to the pool decreases when connected to the Baby Bear. To keep the pool water properly filtered, longer pump run times may be necessary. Check your pool pump user manual to...
Select an unshaded location on flat ground near the pool that will receive full sunlight exposure for most of the day. Due to the Baby Bear Legs, the collector will sit at the ideal angle for solar collection. The Baby Bear should be placed in an accessible location for winterizing. Note: Winter is considered anytime air temperature is below 40°F.
Once the Baby Bear is assembled, connect the hoses. Using one flexible hose and hose clamp, and connect it from the pool filter directly to the inlet of the Baby Bear. Position the hose clamps as shown in the figure and hand tighten them. Apply the second hose and hose clamps from the outlet of the solar collector directly into the pool inlet.
Operation If the solar collector is full of water and has been sitting in the sun without the pump WARNING: running, the water can get very hot. Hot water can cause burns, so be sure that everyone is away from the pool inlet each time the solar is turned on. During operation, when the solar system is running efficiently, the solar collector will be cool to the touch.