AEG FAVORIT 55000 I User Manual page 33

USING THE DETERGENT
A B
30
20
SETTING AND STARTING A
PROGRAMME
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation:
• All the phase indicators come on.
• The time of the last set programme
flashes in the display.
If the control panel shows other condi-
tions, press and hold Multitab and De-
lay at the same time until the appliance
is in setting mode.
Starting a programme without
delay start
1. Press the release button (B) to
A
+ -
2. Put the detergent in the compart-
3. If the programme has a prewash
C
4. If you use detergent tablets, put
5. Close the lid. Make sure that the
1. Open the water tap.
2. Press the on/off button to activate
3. Close the appliance door.
4. Make sure that the appliance is in
5. Turn the programme knob until the
6. Press Start. The programme starts.
CAUTION!
Use only detergents for dish-
washers.
open the lid (C).
ment (A) .
phase, put a small quantity of de-
tergent on the inner part of the ap-
pliance door.
the tablet in the compartment (A).
release button locks into position.
Do not use more than the cor-
rect quantity of detergent. Refer
to the instructions on the deter-
gent packaging.
Detergent tablets do not fully
dissolve with short programmes
and detergent residues can stay
on the dishes.
We recommend that you use
detergent tablets with long pro-
grammes.
the appliance.
setting mode.
marker on the knob is aligned with
the programme you want to set.
• The programme duration flashes
in the display.
• The phase indicators of the set
programme come on.
• Only the indicator of the phase in
operation stays on.
• The display shows the pro-
gramme duration that decreases
with steps of 1 minute.
ENGLISH 33