Wiring - Krix MX-10 Installation Manual

The terminals for each speaker are located at
the rear of the speaker. Wiring the speakers
will need to be done before placing the
speakers into the cavity.
The left, centre and right main speakers are
not designed to be connected to an amplifier
in a bi-amp configuration. Each main speaker
has only one set of speaker terminals, so
therefore only one length of 2 core speaker
cable is required.
Wire Size
18 AWG (0.823 mm2)
16 AWG (1.31 mm2)
14 AWG (2.08 mm2)
12 AWG (3.31 mm2)
10 AWG (5.26 mm2)

WIRING

Processors, amplifiers and other components
may be mounted remotely in equipment
racks at considerable distances from the
screen loudspeakers. Therefore, the use of
high quality, flexible, multi-stranded copper
cables of suitable gauge are recommended
for best performance.
t
4 Ω Load
4.9 m (16 ft)
7.3 m (24 ft)
12 m (40 ft)
18 m (60 ft)
30 m (100 ft)
13
For cable runs up to 10m in length, a
minimum 14AWG gauge cable should be
specified for the main left, main centre and
main right loudspeakers, and at least 12AWG
cable for the subwoofers. For longer cable
runs consider using thicker cable. If in doubt,
consult your Krix authorised dealer or system
designer for recommendations regarding the
gauge of cable.
6 Ω Load
7.3 m (24 ft)
11 m (36 ft)
18 m (60 ft)
27 m (90 ft)
46 m (150 ft)
8 Ω Load
9.7 m (32 ft)
15 m (48 ft)
24 m (80 ft)
36 m (120 ft)
61 m (200 ft)