Scandomestic SKB 182 W User Manual page 15

Changing the door direction
1. Before reversing the door's opening direction, unplug the
appliance and remove all food.
2. Using a flat screwdriver pry and remove hinge caps (if
appropriate).
3. Using a Phillips screwdriver remove the door upper hinge
while holding the door (step. 1).
4. Tilt the appliance (up to 40 degrees) to have sufficient
access to the lower hinge (step. 2).
5. Using a Phillips screwdriver, remove the lower door
hinge.
6. Attach the lower hinge on the other side (step. 3).
7. Position the door assembly in such a way so that pin of
the lower hinge is aligned with the appropriate hole of
the lower door bracket.
8. Attach the middle hinge on the other side of the
appliance so that the lower pin of the middle hinge is
aligned with the appropriate hole of the upper door
bracket. Position the second door assembly so that the
upper pin of the middle hinge is aligned with the
appropriate hole of the lower door bracket (step 4). *
9. Check that the door is properly aligned with the cabinet.
10. Switch on the appliance as described in the relevant
section of its operating instructions.
* This action applies to appliances with both refrigeration and
freezer chambers.