AEG LR73CU86 User Manual page 25

washing phase indicators (when available)
and an indicative programme duration.
2. To change the temperature and/or the
spin speed, touch the related buttons.
3. If desired, set one or more options by
touching the related buttons. The related
indicators come on in the display and the
given information changes accordingly.
In case a selection is not possible, no
indicator comes on and an acoustic
signal sounds.
12.5 Starting a programme with the
delay start
1. Touch this repeatedly until the display
shows the desired delay time. The
indicator comes on.
2. Touch the Start/Pauze - Départ/Pause
button.
The appliance starts the countdown of the
delay start.
When the countdown is completed, the
programme starts.
The ProSense estimation starts at the
end of the countdown.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pauze - Départ/Pause
button to pause the appliance. The
related indicator flashes.
2. Touch the Startuitstel - Départ Différé
button repeatedly until the display shows
.
3. Touch the Start/Pauze - Départ/Pause
button again to start the programme
immediately.
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Start/Pauze - Départ/Pause
button to pause the appliance. The
related indicator flashes.
2. Touch the Startuitstel - Départ Différé
button repeatedly until the display shows
the desired delay time.
3. Touch the Start/Pauze - Départ/Pause
button again to start the new countdown.
12.6 Starting a programme
Touch the Start/Pauze - Départ/Pause button
to start the programme.
The related indicator stops flashing and stays
on.
The programme starts, the door is locked.
The display shows the indicator
The drain pump can operate shortly
before the appliance fills water.
12.7 The ProSense System load
detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pauze - Départ/
Pause button, the maximum declared load
indicator goes off, the indicator
the ProSense System starts the laundry load
detection:
1. The appliance detects the load in the first
30 seconds, the indicator
digit area shows
rotates shortly.
2. At the end of the load detection, the
indicator stop flashing. The
programme duration will be adjusted
accordingly and could increase or
decrease. After further 30 seconds, the
water filling starts.
At the end of the load detection, in case of
drum overload, the indicator
flashing in the display.
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
.
flashes,
flashes. the
and the drum
is
ENGLISH 25