Table of Contents
Advertisement
8.5 Vlekken/Voorw. - Taches/Prélav.
Press this button repeatedly to activate one of
the two options.
The relevant indicator goes on in the display.
• Taches - Vlekken
Select this option to add an anti-stain
phase to a programme in order to treat
heavily soiled or stained laundry with stain
remover.
Pour the stain remover into compartment
. The stain remover will be added in
the appropriate phase of the washing
programme.
This option is not available with a
temperature lower than 40 °C.
• Voorwas - Prélavage
Use this option to add a pre-wash phase
at 30 °C before the washing phase.
This option is recommended for heavily
soiled laundry, especially if containing
sand, dust , mud and other solid particles.
The options can increase the programme
duration.
These two options cannot be set
together.
8.6 Extra
With this button you can select one of the
following options:
• Skipping wash phase - Alleen spoelen -
Rinçage option
The appliance performs only the rinsing
phase, the spinning and the draining
phases of the selected programme. When
this option is set the washing phase is not
performed.
• Centrif./Pompen - Essorage/Vidange
option
The appliance performs only final spinning
or only draining phase of selected
programme. By selecting No Spin
16
ENGLISH
option via Centrifugeren - Essorage button
only Drain cycle can be configured.
The corresponding indicator above the touch
button illuminates.
8.7 Plus Steam
This option adds a steam phase followed by a
short anti-crease phase at the end of the
washing programme. The steam phase
reduces fabric creasing and facilitates the
fabric ironing.
The drum performs smooth movements for
about 30 minutes. The duration of the steam
phase changes accordingly to the selection.
When Plus Steam option is set the
programme ends up with an anticrease phase
during which the drum is occasionally rotated
to prevent wrinkling. The display shows
indicator
is steady on and the indicator
starts flashing. Start/Pauze - Départ/Pause
button is lit as well. At the end of the
anticrease phase the drum definitely stops,
the indicator goes off, the door unlocks. User
at any moment can terminate the anticrease
phase by:
• pressing the Aan/Uit - Marche/Arrêt button
for a few seconds to activate or deactivate
the appliance;
• turning the selector knob to another
position.
A small laundry load helps to reach better
results.
8.8 Pods®
Touch this button to activate or deactivate the
Pods® option .
When activated the relevant indicator is on.
Follow the Pods manufacturer's dosage and
storage recommendations.
Put maximum two tablets or single-dose
detergents in the Pods® compartment in the
detergent dispenser drawer.
The option remains active also for next cycles
until it is deactivated and if it is selectable
with the set programme.
the
Advertisement
Table of Contents
