Craftsman 152.213371 Owner's Manual page 13

Fig. 13
V
/
/
1,
Align the four hobs in intake port (A) with the
mounting hobs in flange (B) of blower and motor
assembly and fasten with four M4,2 sheet metal
screws (C), See figure 14,
Fig. 15
0
0
8,
Attach the lower dust bag retaining clip (V) to the
dust collector drum, Align both hobs (W) in the
retaining clip with the two hobs in the drum, insert
a 1/4-20 x 5/8" hex head screw through each hob
in the retaining clip and drum, Place a 1/4" fiat
washer and 1/4-20 hex nut onto screw inside of the
drum, Repeat this process for the other three
retaining clips and tighten all hardware,
See figure 13,
iNTAKE PORT TO
BLOWER MOTOR ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR
DISCONNECTED FROM THE POWER SOURCE.
E
D
2,
Attach one intake port cap (D) to the intake port (E),
The intake port caps must be placed into the intake
ports when the intakes are not in use,
See figure 15,
IMPORTANT: When connecting an intake hose to one
or both intake ports, DO NOT REMOVE THE INTAKE
PORT CAP COLLARS (F} FROM THE INTAKE
PORTS, Slide the collar further back when attaching a
hose, See figure 15,
Fig. 14
B
NLTER AND COLLECTION BAG
TO DRUM ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
A
1, Hook the loop (A) on the top filter bag onto hook
(B) of the upper support rod, See figure 17,
13