Bosch B1 RKM 10015 Instructions For Use Manual page 27

Permanent installation
Dehumidification
The appliance can be installed on a permanent
basis using window/wall Optional Accessory,
reference B1 RKZ 06009, available from your
supplier.
A hole must be made in the wall and the wall
accessory fitted in order to expel hot air.
Store the diffusion duct away and connect the air
expulsion duct to the accessory.
Only the transparent end section of the
accessory is used when air is to be expelled
through a window on a permanent basis. A 10.5
cm. diameter hole must be made in the glass in
order to fit the accessory.
N.B.
• Do not extend the hot-air expulsion duct more
than necessary (maximum length: 140 cm.).
• There must be a distance of at least 70 cm.
between the floor and the end of the duct.
• Do not bend the duct too sharply when
positioning it.
This can impede proper hot-air expulsion, which
may reduce cooling efficiency.
When set to, the appliance removes humidity from
the atmosphere. As a result, there is no
temperature regulation.
Turn drainage stopcock 90° in an anti-clockwise
direction.
Remove stopcock plug and insert drainage pipe.
stored in the main filter compartment.
Place a bowl at the drainage pipe outlet to collect
the condensed water in.
Put the air extraction duct in storage position.
Select the "Dehumidification"
mode button.
The speed of the ventilator can be set to five
different levels, from 1 (minimum) to 5
(maximum), using the
Dehumidification power depends on the
ventilator speed selected.
function with the
and the buttons.
27