Table of Contents
Advertisement
2
SETUP
–
Recharge the battery. (
–
Plug in connector
S00801-10
–
Remove the rear fairing. (
–
4 markings
drill holes to the specified diameter in three stages.
Guideline
Hole diameter for grab handles
S00802-10
–
Remove screws
–
Fit the rear fairing. (
S00803-10
–
Mount the reflector.
700217-01
–
Insert the rubber sleeves
–
Position the engine guard. Mount and tighten screws
Guideline
Remaining screws, chassis
Operation as 2-seater
–
Mount rear footrest bracket. (
Operation as 1-seater (at customer request only)
–
Mount the rubber strap for the side stand. (
S00804-10
–
Mount heel protector. (
–
Refuel. (
p. 7)
on the starter relay.
p. 11)
are found on the underside of the rear fairing. At these location,
.
p. 11)
in the footrest bracket.
p. 11)
Warning
Forfeiture of homologation and insurance cover The vehicle is
homologated as 2-seater. If the heel protector is fitted instead of the
footrest bracket, the vehicle no longer conforms to the homologation and
must not be operated in this form without alterations to the registration
papers.
–
Set up and operate the vehicle as a 2-seater or have changes made
to the registration papers.
p. 12)
p. 12)
14.5 mm (0.571 in)
.
M6
10 Nm (7.4 lbf ft)
p. 12)
5
Advertisement
Table of Contents
