Related Manuals for WellAir Plasma Air PLASMA BAR Series
Summary of Contents for WellAir Plasma Air PLASMA BAR Series
- Page 1 INSTALLATION, OPERATION & MAINTENANCE MANUAL PLASMA BAR SERIES MODELS: PB-18, PB-24, PB-30, PB-36, PB-42, PB-48, PB-54, PB-60, PB-66, PB-72, PB-78, PB-84, PB-90, PB-96 REV 07/2023 Needlepoint Ionizer www.plasma-air.com...
- Page 2 INTRODUCTION The Plasma BAR is a commercial quality, remote mounted needle point ion generator intended for installation in air handling units (AHU) and rooftop units (RTU). The Plasma BAR was designed to be mounted on the entering air side of a cooling coil inside of an AHU or RTU. The Plasma BAR is available in lengths of 18 inches up to 96 inches in 6 inch increments to suit a wide variety of AHU or RTU size applications.
- Page 3 IF NOT WIRED FROM FACTORY, PROVIDE FIELD WIRING CONNECTING 2 BARS. CENTER PLASMA BAR ON ENTERING FACE OF COOLING COIL • For installations that have a cooling coil height of greater than 60" or where one CONTROL BAR is insufficient, multiple Plasma PANEL BARs are required.
- Page 4 DUAL BAR SYSTEM WIRING INSTRUCTIONS For applications where two linked BARs are required, follow the wiring instructions listed below. Accessories Required: 3 x Ring Terminals per (2) BAR system. Remove the white cover plate with the Plasma Air logo from BAR #1 exposing its ring terminals. Snip the control panel connector off the end of the wiring from BAR #2 and attach the new ring terminals to the loose wire ends.
Need help?
Do you have a question about the Plasma Air PLASMA BAR Series and is the answer not in the manual?
Questions and answers