Raid Migration Instructions - MSI X48 Platinum Series Manual

RAID Migration Instructions

The Intel Matrix Storage Console offers the flexibility to upgrade from a single SATA
hard drive to RAID configuration when an additional SATA hard drive is added to the
system. This process will create a new RAID volume from an existing disk. However,
several important steps must be followed at the time the system is first configured in
order to take advantage of RAID when upgrading to a second SATA hard drive:
1. BIOS must be configured for RAID before installing W indows on the single
SATA hard drive. Refer to Chapter 3. BIOS for properly setting.
2. Install the Intel Application Accelerator RAID Driver during W indows Setup.
Refer to Installing Software for instructions on installing the driver dur-
ing W indows Setup.
3. Install the Intel Matrix Storage Console after the operating system is installed.
To create a volume from an existing disk, complete the following steps:
Important
A Create from Existing Disk operation will delete all existing data from the
added disk and the data cannot be recovered. It is critical to backup all
important data on the added disk before proceeding. However, during the
migration process, the data on the source disk is preserved.
After the Intel Matrix Storage Console has been successfully installed and the sys-
tem has rebooted, click on the Intel Application Accelerator shortcut link (Start --> All
Programs --> Intel M atrix Storage Manager --> Intel Matrix Storage Console)
and the following window will appear:
Intel SATA RAID
C-15