Page 1
POND & AQUARIUM WATER PUMP 1400PP / 3000PP / 4500PP SUBMERSIBLE USE ONLY - SUITABLE ANTI CORROSIVE AND HIGHLY FOR FRESH AND SALT WATER DURABLE PUMP BODY & CASING SHAFT MADE OF QUALITY CERAMIC - COMPLETELY SEALED MOTOR- ANTI-CORROSIVE & WATERPROOF...
Page 2
To ensure your new pond pump is set up and running correctly, and to prevent any accidental damage or injury, please read and follow the below instructions carefully before using your product. SAFETY IMPORTANT! Disconnect the mains electricity supply before attempting any installation / maintenance of any kind.
Page 3
If the appliance shows any signs of water leakage or the RCD unit switches · off, disconnect the unit from the power supply and consult the retailer where you purchased the unit. Do not install or store this unit where it will be exposed to temperatures ·...
PARTS DIAGRAM 1400PP BACK COVER IMPELLER O-RING BACK CASE SHAFT RUBBER BEARING SUCTION CUPS IMPELLER COVER BASE PLATE FRONT COVER OUTLET MAIN BODY COVER CAP O-RING...
Page 5
PARTS DIAGRAM 3000PP / 4500PP O-RING O-RING SUCTION CUPS OUTLET IMPELLER COVER BASE PLATE RUBBER BEARING SCREW MAIN BODY IMPELLER COVER CAP BACK CASE SHAFT FRONT COVER BACK COVER...
INSTALLATION & USE The All Pond Solutions PP pump range can be used to circulate water, pump to and from a separate filtration system or water features using suitable flexible hose (flexible hosing sold separately). Please read the below instructions carefully before beginning to set up your pump.
4. Position the unit - fully submerge your PP unit. Place it on a level and sturdy surface at the bottom of your pond, this is to avoid silt entering the pump causing excessive wear and increasing pump cage cleaning. If you have a pond liner, use the provided suction cups.
Page 8
O-rings It is vital that O-rings are regularly inspected and replaced as the rubber watertight seal will perish over time, which may cause your unit to leak. Before replacing your o-rings, ensure they are well lubricated to ensure the seal is kept water tight.
The impeller can then be gently pulled away from the housing and inspected for damage. Clear the fittings and parts of any waste build-up. 1400PP 3000PP 4500PP Reassemble the unit. Ensure the O-rings are in place to avoid leakage. SPECIFICATIONS...
TROUBLESHOOTING Slow Flow Rate Slow Flow Rate 1. For optimum function of the unit, we highly recommend the pump is positioned on a brick, so it is not resting directly on the bottom on the pond. This is to prevent large clumps of debris blocking the inlets and restricting the flow. 2.
WARRANTY The All Pond Solutions PP pump range is guaranteed against defects in material or workmanship under normal pond usage and comes with 12 months warranty for all electrical parts. The warranty period commences from the date of purchase. If you require support on how to use your unit, replacement parts or if your pump develops a fault during the warranty period, please contact the supplier of your unit.
Page 12
All Pet Solutions Limited Trading as All Pond Solutions Unit 203 Riverside Way, Uxbridge, Middlesex, England, UB8 2YF...