Related Manuals for AllPondSolutions AP-1.5-KIT
Summary of Contents for AllPondSolutions AP-1.5-KIT
- Page 1 AQUARIUM AIR PUMP AP-1.5-KIT / AP-3-KIT LOW NOISE OPERATION NON-RETURN VALVE INCLUDED HIGH OUTPUT AIR STONE & HOSE INCLUDED SINGLE/DUAL OUTLET MULTI-SPEED CONTROL...
- Page 2 To ensure your new aquarium filter is set up and running correctly, and to prevent any accidental damage or injury, please read and follow the below instructions carefully before using your product. SAFETY IMPORTANT! Disconnect the mains electricity supply before attempting any installation / maintenance of any kind.
-
Page 3: Parts Diagram
The air pump will overheat and become damaged if it cannot operate adequately. Never · shut off any of the air outlets, make sure the airline is not obstructed or blocked and that the air stones are replaced regularly and are of a suitable standard. Please note –... - Page 4 PARTS DIAGRAM AP-3 FILTER CASING PUMP CASING PUMP BASE SCREWS AIR FLOW CONTROLLER AIR COTTON FILTER MOTOR COMPONENTS DIAPHRAGM...
- Page 5 ELECTRIC This unit comes complete with a generous supply of 3 core cable, however should any additional cable be required, the use of an approved waterproof cable connector with a proper rating is essential. A cord rated for less amperes or watts than the appliance rating may overheat.
-
Page 6: Air Flow Adjustment
2. Place the air pump on a surface higher than the water level, such as a shelf. The surface should be at least 12 inches (30 Drip Loop cm) higher than the water level of the aquarium, but not be positioned directly above the aquarium. -
Page 7: Back Pressure
Regularly clean your air hose and air stone to ensure maximum output and improved lifespan of the air pump. The air hose should be inspected at the same time that regular aquarium maintenance is carried out. Carefully remove any sections that are kinked or pinched and replace if necessary. -
Page 8: Troubleshooting
2. Remove the old diaphragm(s) from the valve housing and then fit the new diaphragms. 3. Make sure the air pump is correctly put back together and securely fastened with the screws. TROUBLESHOOTING No Air Is Being Produced 1. Ensure that the air pump is plugged 2. -
Page 9: Specifications
SPECIFICATIONS AP-1.5 AP-3.5 MODEL 220V/50Hz 220V/50Hz VOLTAGE POWER 0.04MPa PRESSURE 0.02MPa 3L/min OUTPUT 1.5L/min 0.31kg WEIGHT 0.29kg DIMENSIONS 135x70x55 135x70x55 (LxWxH) mm CONTENTS AP-1.5-KIT AP-3.5-KIT MODEL AIR PUMP AIR STONE NON RETURN VALVE AIR HOSE... -
Page 10: Warranty
WARRANTY The All Pond Solutions AP series is guaranteed against defects in material or workmanship under normal aquarium usage and comes with 12 months warranty for all electrical parts. The warranty period commences from the date of purchase. If you require support on how to use your unit, replacement parts or if your air pump develops a fault during the warranty period, please contact the supplier of your unit. - Page 11 No liability is assumed with respect to loss or damage to livestock or personal property irrespective of the cause thereof. Please ensure that only genuine All Pond Solutions components are used when completing a replacement or repair. Spare parts are available at our official website or from your local supplier.
- Page 12 All Pet Solutions Limited Trading as All Pond Solutions Unit 203 Riverside Way, Uxbridge, Middlesex, England, UB8 2YF...