Tool Menu; Ez Flash 3 Utility - CADnetwork Creator! Extreme Rev3 Setup Manual

Boot Option Priorities
These items specify the boot device priority sequence from the available devices. The
number of device items that appears on the screen depends on the number of devices
installed in the system.
•
•
Boot Override
These items displays the available devices. The number of device items that appears on
the screen depends on the number of devices installed in the system. Click an item to start
booting from the selected device.
3.9

Tool menu

The Tool menu items allow you to configure options for special functions. Select an item then
press <Enter> to display the submenu.
Setup Animator
This item allows you to enable or disable the Setup animator.
Configuration options: [Disabled] [Enabled]
3.9.1

EZ Flash 3 Utility

This item allows you to run EZ Flash 3. When you press <Enter>, a confirmation
message appears. Use the left/right arrow key to select between [Yes] or [No], then press
<Enter> to confirm your choice.
For more details, refer to section 3.11.2 EZ Flash 3.
22
®
To access Windows OS in Safe Mode, press <F8> after POST (Windows
supported).
To select the boot device during system startup, press <F8> when the Logo
appears.
®
8 not
BIOS Setup