Setup
Turning the power
on for the camera
Open the cover of the camera,
and then slide the power slide
switch (page 13, J) to ON .
Registering the
camera
Before you can use the camera, it
must be registered to the access
point.
You can register each camera by
using the registration buttons or
the [HomeHawk] app.
Note:
R Before registering the camera,
make sure the camera is turned
on, and that the AC adaptor of
the access point is connected
and the access point is
powered.
16
HNC710_(en_en)_0207_ver.110.pdf
For assistance, please visit http://shop.panasonic.com/support
16
Using registration buttons
1
Access point:
Press and hold MSETUPN until
the LED indicator ( 1 ) blinks
slowly in green.
2
Camera:
Press and hold MSETUPN until
the LED indicator ( 2 ) blinks
slowly in green.
2
R When registration is
completed, the camera
sounds one long beep.
Note:
R If registration fails, the camera
sounds several short beeps.
Using the app
You can change the name of the
camera using the [HomeHawk]
app. For more information, refer to
the User's Guide (page 20).
1
2018/02/07
20:11:47