Philips EasyKey DDL702E User Manual page 9

Put the compressed spring and
5
square shaft into the square shaft
hole of the inside escutcheon
accordingly.
Remove the deco cover
7
and press the button
at the top of the inside
escutcheon to remove
the battery cover,
and fasten the inside
escutcheon with two
M6 mounting screws.
Attention
After finishing the strike installation, please check whether the smart
lock can lock or unlock normally.
Put the deco cover
8
back, install the
batteries and install
the battery cover and
strike.
RES
Insert the cable of both outside
6
escutcheon and mortise into the
corresponding sockets on the
inside escutcheon. Then insert
the square shaft of the inside
escutcheon to the rotary hole
on the mortise until the inside
escutcheon is close to the surface
of the door.
Mortise cable
Attention
Make sure the escutcheon cable and
the mortise cable are hidden in the slot
on both sides of the square shaft, and
also hide the extra cables in the door
hole or the inside escutcheon.
Mortise cable
connector
Escutcheon
cable
connector
Check whether
9
the rotary knob,
mechanical key, and
all other components
work properly.
7