Videofied KF210 Installation Sheet

INSTALLATION SHEET
Press and release the keyfob button to send an assistance request to the Alarm Receiving Center, and, depending on the Videofied
system programming, trigger the sirens.
A beep is emitted when pressing the button. The reception of the request is confirmed by a green double-flash from the keyfob
LED.
> Note : This keyfob is powered by a CR3032 lithium battery with a 5-year battery life.
KF210/611/712 1-BUTTON REMOTE KEYFOB
Operation
Keyfob registration
The alarm panel shall be in "device registration" mode,
the keypad displays "PRESS PROGRAM BUTTON OF
DEVICE".
The keyfob is provided with the battery installed. Press
the keyfob button for 10 seconds.
When releasing the button, the keyfob beeps and
flashes every second then registers.
If the keyfob is not recorded, confirm that the keypad is
displaying:
PRESS PROGRAM
BUTTON OF DEVICE
then press and hold the keyfob button again (by
strongly pressing the button).
DOC. - REF. 217-KF PANIC
MODIF. DATE : NOVEMBER 2016
®
1