Videofied KF 240 Installation Sheet

INSTALLATION SHEET
Press and hold
simultaneously for 5 seconds
Commands
Full
Arming
Partial
arming 1
Siren alert after
holding for 2 seconds
The keyfob emits delay beeps when the system is armed. You can determine if a door contact is still open.
If a device is detecting while the panel is arming, the keyfob emits a 4-second long beep.
You do not need to wait for the beeps to stop to leave the premises. The beeps will automatically stop after the configured exit delay.
KF 240/641/742 4-BUTTONS REMOTE KEYFOB
___ & __
Disarming
Partial
arming 2
Silent alert after
holding for 2 seconds
Programming
Enable the device recording mode on the panel, the keypad
will display "PRESS PROGRAM BUTTON OF DEVICE".
Press and hold the keyfob
When releasing, the keyfob emits a beep and a flash every
second then the keyfob is recorded by the panel.
If the keyfob is not recorded, confirm that the keypad is
displaying:
PRESS PROGRAM
BUTTON OF DEVICE
then press and hold the keyfob
strongly pressing the buttons).
Operation
Press briefly and release the corresponding button to arm
(full arming or partial arming) or disarm.
The first beep confirms the button has been pressed. Two beeps
confirm that the panel has received the command. If the panel has
not received the command, only one beep is emitted by the keyfob.
A red double flash confirm the system full or partial arming. A green
double flash confirms disarming.
To trigger an alert, press and hold one of the partial arming keys for
2 seconds.
> Note : This keyfob is powered by a CR3032 lithium battery with a
5-year battery life.
DOC. - REF. 217-KF
EDITION DATE : NOVEMBER 2016
& keys simultaneously.
& keys again (by
1