Table of Contents
Advertisement
Conversion to a different gas type
Changing the gas type
Change the gas connection piece.
■
Change the burner nozzles.
■
The bypass nozzles of the burner taps will need to be
■
adjusted depending on the gas setting configured at the
factory.
If fitted, the nozzles for the oven burner and grill burner must
■
also be changed.
The numbers on the burners refer to their diameter. You can
find more information about which gas types can be used with
the appliance and the appropriate gas nozzles in the section
entitled "Technical specifications – Gas".
After conversion
Always test for leaks after converting the appliance to a
■
different gas type. See the section entitled "Testing for leaks"
for details.
The burning must be checked after the product has been
■
converted to a different gas type. See the section entitled
"Correct burning" for details.
Enter the new gas type and the new gas pressure in the
■
table. See the section entitled "Important information".
Parts for gas conversion
The parts required for the gas conversion procedure described
are given below.
To find out the correct nozzle diameter, see the table entitled
"Technical data – Gas".
Always use a new seal.
The gas connecting piece may vary depending on the gas type
and the regulations in force in your country.
(*) A gas connection must never be made without these parts.
6
Bypass nozzle
Burner nozzle
(*) Seal
(*) Connecting piece for natural
gas
(NG: G20, G25)
TS 61-210 EN 10226 R
^
EN 10226 R
^
(*) Connecting piece for natural
gas
(NG: G20, G25)
TS EN ISO 228 G
^
EN ISO 228 G
^
Replacing the burner nozzles
Make sure all the knobs on the control panel are turned off.
1.
Close the gas connection shut-off.
2.
Remove the pan supports and the burner parts.
3.
Removing the burner nozzles
4.
Look up the burner nozzles in the table. You can find
5.
information about this in the section entitled "Technical data –
Gas".
Position the new burner nozzles on the corresponding
6.
burners and screw them in place. (Tightening torque 4 Nm)
If the burner nozzles have been replaced, check that they are
not leaking. You can find information about this in the section
entitled "Testing for leaks".
(*) Connecting piece for liquid gas
(LPG: G30, G31)
Connection piece
Advertisement
Table of Contents
