Table of Contents
Advertisement
OPERATION
When the work equipment angle sensor has been
●
removed and installed again, the automatic stop position
will change.
When the cutting edge of the bucket is lowered to the
●
ground surface, the depth display does not become 0.0
m (0.0 in).
The depth display changes according to the position of
●
the bucket.
The boom stops before the point set for the depth mode.
●
(This happens particularly when the boom is lowered
slowly.)
In cold weather, the stop position changes when the
●
interference prevention device and automatic control
device are actuated. (This returns to normal when the
hydraulic oil is warmed up.)
TROUBLESHOOTING
3-123
Advertisement
Chapters
Table of Contents
