Texas A/S WRX2000 User Manual page 12

Charging
Fig. 10a
A full charge takes around 60 min for 2.0 Ah battery and
120 min for 4.0 Ah battery.
•
Only use the original charger*
•
Do not try to charge other type of batteries in the
charger, other than the original batteries with art.
no. 90063245 (2.0 Ah) or 90063246 (4.0 Ah).
•
Keep the charger in a dry and warm environment
(10-25 degrees C) and only use it indoor. It should
be connected to a normal 230V AC socket.
•
Before the battery is being used the first time, it is
recommended to charge it fully.
•
The surface of the battery can become warm
during charging. This is normal.
•
Do not cover battery or charger during charging.
Allow free ventilation of air.
Insert the battery into the slots of the charger and
slide it into place until it locks.
There are 4 lights on the charger indicating the status
and state of charge of the battery.
Important: The charger will stop, when the battery is
full. However, it is not recommended to leave the
battery in charger for more than 24 hours.
It is recommended to drain the battery completely and
fully charge it whenever possible, as it can increase
the health of the battery. But partial charge will not
damage the battery.
To remove the battery from the charger, hold the
button down and pull the battery out.
Before winter storage, the battery should be fully
charged and kept warm at 10-20 degrees C. Charge it
every 3 months. Make sure to keep ventilation holes
clean and free from dirt.
Store the charger indoor between 5-25 degrees C.
Status
Charging
Fully charged
Evaluate
Defective
Storage
Clean the machine after use. Make sure no debris gets
in through the cooling slots of the motor housing. Store
the cleaner in a frost free area, out of reach of children.
During winter storage, the battery should be fully
charged and kept warm at 10-20 degrees C. Charge it
every 3 months. Make sure to keep ventilation holes
clean and free from dirt.
Store the charger indoor between 5-25 degrees C.
Specifications
Model
Battery voltage
Brush speed
Brush size
Net weight
Battery type
Battery capacity
Charging time
Operate time
Charging unit
Warranty terms and conditions
The warranty period is 2 years for private end users in
EU countries.
Products sold for commercial use, only have a warranty
period of 1 year.
The warranty covers material and/or fabrication faults.
Normal wear and replacement of wearing parts are
NOT covered by the warranty.
Wearing parts, which are NOT covered for more than
12 months:
•
Brushes
•
Wheel
•
Guards
•
Battery: If the battery is not stored correct (frost-free
and recharged every 3 months), the durability is
only guaranteed for 6 months.
The warranty does NOT cover damages/faults caused
by:
•
Lack of service and maintenance
•
Structural changes
•
Exposure to unusual external conditions
•
Damages to the bodywork, protection guards,
panels etc.
•
If the machine has been improperly used or
overloaded
•
Use of unoriginal spare parts.
•
Other conditions where Texas cannot be held
responsible.
* We reserve the right to change the conditions and
accept no liability for any misprints
WRX2000
20V
1200 /min
100 mm
2 kg
Lithium-ion
2.0 Ah
1 hour
Up to 35 min.
220-240V~50/60 Hz
12