Advertisement
IV. Additional Functions
1. Function of memory after short-time removal of kettle: If the kettle is
removed from its power base for about 1 minute and then put back to its base
during use, it will continue to execute the unfinished program.
2. Function of power off memory: If the kettle is unplugged for about 1 minute
and then plugged again during use, it will continue to execute the unfinished
program.
3. If the kettle is operating without water, or if it is overheated because the
ingredients in it is overcooked, it will detect it and power off automatically and
display nothing on its display screen. After the temperature in the kettle has
declined or cold water has been added into it, "OFF" will appear on the display
screen. Remember that there will be sticky bottoms or a have a burnt scent
when the bottom of the kettle is heated, it needs to be cleaned that continue to
use.
4. When the NTC sensor has detected overheating, "E2" will appear on the
display screen and it needs to wait for the temperature to drop before it can be
used normally. When NTC has an open circuit, "E3" will appear on the display
screen. Please contact our after-sales service department for inspection and
maintenance. ("E2" and "E3" both suggest a fault).
VII. Cleaning and Maintenance
1.Please keep the power base surface clean. After use for some time, remove the
dirt or water on the base surface.
2. For safety, do not immerse the kettle body into water or allow any liquid to
flow into its interior or base.
3.Do not start any operation,heating and boiling when there is no water in it,
otherwise the product life will be shortened.
4.To avoid electric shocks due to damage of the kettle, do not immerse the
kettle or its power cable, plug or power base into water or any other liquid.
5. Use the kettle on the power base delivered with the kettle only.
13
Advertisement
