Radio Shack 1201669 - Portable Bluetooth Transmitter Manual

This transmitter enables devices without Bluetooth capabilities to connect to Bluetooth-enabled devices. For example, you can wirelessly connect a phone or MP3 player to a Bluetooth-enabled speaker or headphones. Please read this user's guide before using your new transmitter.

Package Contents

• Portable Bluetooth Transmitter
• Micro-USB Charging Cable
• User's Guide

Specifications

Specifications are subject to change and improvement without notice. Actual product may vary from the images found in this document.

Charge Your Transmitter

The charging indicator lights red when charging and turns off when fully charged. Unplug the charging cable when the transmitter is fully charged.
Note: When the battery is low, the charging indicator flashes red. The transmitter powers off if not charged within 5 minutes.

Lithium Battery Notes:

• Recycle lithium batteries. Do not dispose of them in the trash.
• Do not burn or bury batteries. Do not puncture or crush. Do not disassemble.
• Charge batteries on a fireproof surface away from flammable items or liquids.
• Do not charge inside an automobile, especially while driving.
• If the electrolyte in the cells should get on your skin, thoroughly wash with soap and water. If in the eyes, rinse thoroughly with cool water. Immediately seek medical attention.
• Follow the instructions for charging the transmitter and do not charge longer than recommended. Unplug the USB cable when the battery is charged.

Pairing Button & Bluetooth Indicator

• Flashes quickly – Searching last paired device
• Flashes slowly – Pairing
• Lights steadily – Paired

Use Your Transmitter

1. Turn on your transmitter and press the Pairing button to go to pairing mode.
2. Turn on your speaker and make sure your speaker is in pairing mode (refer to your speaker's user's guide). The transmitter pairs automatically, and the Bluetooth indicator lights steadily.
3. Plug your transmitter's built-in cable into your audio device's 3.5mm headphone jack.
4. Use your audio device's playback controls.
5. Turn off your transmitter after use.

Device Not Pairing?

Many Bluetooth-enabled devices, such as speakers, remember the most recently paired source (music, smartphone, etc.) and automatically reconnect when turned on. This is convenient, but can prevent you from connecting to a new source.
If you can't pair your transmitter, you may need to disconnect it from its previous source.

Notes:

• If the previously paired speaker is not available, press the Pairing button to search for your speaker.
• To clear your transmitter's pairing history, press and hold the Pairing button for 2 seconds (Bluetooth indicator flashes 5 times).
• If no speaker is connected within 10 minutes, the transmitter automatically enters sleep mode (Bluetooth indicator turns off). To resume searching, turn the transmitter off, then on again.
• The transmitter will disconnect from your speaker if they are too far apart (Bluetooth indicator flashes quickly). To reconnect, move the transmitter closer to the speaker within 1 minute.
• Nearby Bluetooth devices can interfere with your transmitter's connection. If this happens, move other Bluetooth devices at least 32.8 ft. (10m) from your transmitter.