Table of Contents
Advertisement
HCD-DC1
Ver 1.1
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
• MODEL IDENTIFICATION
– Rear Panel –
Power Voltage Indication
Model
US, CND, MX models
AEP, UK models
HK, MY, SP models
• Abbreviation
CND : Canadian model
HK
: Hong Kong model
MX
: Mexican model
MY
: Malaysia model
SP
: Singapore model
4
SECTION 1
SERVICING NOTES
VOLTAGE SELECTOR
Switch
(HK, MY, SP models)
Power Voltage
Incdication
AC: 120 V 60 Hz 75 W
AC: 230 V -50/60 Hz 75 W
AC: 110 – 120/
220 – 240 V / 50/60 Hz 75 W
SERVICE POSTION
In checking the CD block, prepare jig (extension cable J-2501-
011-B).
MAIN board
Connect jig (extension cable J-2501-011-B)
to the MAIN board (CN101) and CD board (CN101).
CD board
Advertisement
Table of Contents
