Advertisement
Quick Links
Advertisement
Summary of Contents for Sencor SCA BA88
- Page 1 SCA BA88 Pre-calibrated sensor module USER´S MANUAL...
- Page 2 Content 1 – Remove old sensor 2 – Install new sensor 3 – User device reset (no need to use it in case of new sensor) 1. Remove old sensor module 1.1 Slide the power switch to “OFF” position (red) 1.2 Remove the bottom cover 1.3 Remove the plastic fuse EN –...
- Page 3 1.4 Remove sensor module 2 Install a new sensor module 2.1 Put the sensor module into the compartment and push it to top position EN – 3...
- Page 4 2.2 install the plastic fuse to fi x the sensor module 2.3 install the cover to the device 2.4 Finish: Slede the power switch to “ON” position (Green) EN – 4...
- Page 5 3. User device reset 1) Turn the device on. ALCO message will be shown. 2) In this mode, press and hold the up and down arrow button and then add the ON/OFF button. After a few seconds of holding these buttons down, the screen below will be shown.
-
Page 6: Instructions And Information Regarding The Disposal Of Used Packaging Materials
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING MATERIALS Dispose of packaging material at a public waste disposal site. DISPOSAL OF USED ELECTRICAL AND ELECTRONIC APPLIANCES The meaning of the symbol on the product, its accessory or packaging indicates that this product shall not be treated as household waste. -
Page 7: Warranty Conditions
Data on presented documents differs from data on products. Cases when the claiming product cannot be indentified according to the presented documents (e.g. the serial number or the warranty seal has been damaged). Authorized service centers Visit www.sencor.eu for detailed information about authorized service centers. EN – 7... - Page 8 ® Designed in Europe by Sencor , Made in China...