Before Initial Use; Control Lamp - easymaxx YDSXT-Z04809 Manual

EN
■ Do not place any heavy objects on the device.
■ Lay the connecting cable in such a way that it does not become squashed or bent and
does not come into contact with hot surfaces.
■ Remove the USB mains adapter from the plug socket before a thunderstorm.
■ In the event of damage / faults, switch the device off / disconnect it from the mains
power immediately. Do not start using the device if there are visible signs of damage
or liquid has penetrated into the device.
■ Do not make any modifi cations to the device. If the device is damaged, it must be
repaired or replaced by the manufacturer, customer service department or a similarly
qualifi ed person (e.g. specialist workshop).
■ Use only original spare parts from the manufacturer in order to guarantee that there
is no interference
■ that may prevent the device from working and to prevent possible damage.

Before Initial Use

PLEASE NOTE
■ Keep children and animals away from plastic bags and fi lms. There is a danger of
suffocation.
1. Check the items supplied for completeness and transport damage. If you fi nd any
damage, do not use the device (!), but rather contact the customer service depart-
ment.
2. Charge the battery (see the "Charging Up the Battery" chapter).
3. Set the date and time on the memory card (see the "Transferring and Viewing Video
Recordings and Photos" – "Setting the Date and Time").

Control Lamp

The light signals of the control lamp (14) have the following meanings:
Control lamp
Lit up constantly red
Flashes red every second
Flashes red and green
Flashes red every 3 seconds
Lit up constantly green
Flashes green once
Flashes green 8 times and goes out No memory card is inserted.
16
Meaning
The battery is charged. The camera is switched
on (in video mode).
The battery charge is less than 10%.
The battery is charging on a computer.
The battery is charging at a plug socket.
The camera is in photo mode.
A photo has been taken.