Operation Handle Control Panel Pressure Knob Heating Element Connector Heating Element Lower Aluminum Plate Silicone Pad Specifications: Item Code: SE-XH-SB-5IN1-S Voltage: 110V/60Hz Power: Control Panel: Digital Control Panel Time Range: 0~999sec. Temp. Range: 0~480°F Packaging: Cardboard packaging Gross Weight: 110lbs (50kg) www.signwarehouse.com •SignWarehouse, Inc.
● The heat press carries a ground line by default, please make sure the socket gets a ground line protector. www.signwarehouse.com •SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 5020 •Toll Free Phone: 1-800-899-5565 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834...
Fig 1: Close up of the control panel. Fig 2: The P-1 is to set the temperature. www.signwarehouse.com •SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 5020 •Toll Free Phone: 1-800-899-5565 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834...
Page 6
FIG 3: To disconnect the power cable, loosen the loosing the wing nuts. collar on the circular connector, then pull the plug away from the control panel housing. www.signwarehouse.com •SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 5020 •Toll Free Phone: 1-800-899-5565 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834...
FIG 7: The mug attachment’s heat platen connects the same way as the shirt attachment, using the circular connector. www.signwarehouse.com •SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 5020 •Toll Free Phone: 1-800-899-5565 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834...
Thumb Screws FIG 8: The thumb screws are located near the opening of the mug attachment. Always make sure they are secured. www.signwarehouse.com •SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 5020 •Toll Free Phone: 1-800-899-5565 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834...
Page 10
Always check the platen is secured. help change out the platen www.signwarehouse.com •SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 5020 •Toll Free Phone: 1-800-899-5565 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834...
Pressure: If the temperature is correct, adjust the pressure. Some films require more pressure to bond the adhesive to the fabric. There should be some resistance when you close the press. If you have verified all of these and the film doesn’t stick, contact SIGNWarehouse customer service or Technical Support for further assistance.
BASICS heat press must be returned in original carton with original packing. Please call 800-699-5517 for an RMA authorization and number or your return will be refused without it. RMAs are good for 10 days. www.signwarehouse.com •SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 5020...
Need help?
Do you have a question about the SE-XH-SB-5IN1-S and is the answer not in the manual?
Questions and answers