Advertisement
4.3. ADC Process
4.3.1 ADC calibration
* MSPG-925
- Component: series Model : 216 (720P@60Hz)
- RGB: Model : 60(1024X768@60Hz)
4.3.2 PC input ADC
4.3.2.1 Auto RGB Gain/Offset Adjustment
- Convert to PC in Input-source
- Signal equipment displays
Output Voltage: 700 m Vp-p
Impress Resolution XGA (1024 x 768 @ 60Hz)
Model : 60
in Pattern Generator
Pattern : 29 in Pattern Generator (MSPG-925 SERIES)
Adjustment pattern (PC )
- Adjust by commanding AUTO_COLOR_ADJUST.
4.3.2.2 Confirmation
- We confirm to address "0xF1 (offset), 0xF2 (gain)" in page
"0x0E" of EEPROM the value is "0xAA' or not.
- If the value is not "0xAA", we adjust once more.
- We can write the ADC values from "0x00~0x05" addresses
in a page "0x0E".0
*Manual ADC process using Service Remocon. After enter
Service Mode by pushing "ADJ" key, execute "Auto-RGBB" by
pushing "
" key at "Auto-RGB".
4.3.3 COMPONENT input ADC
4.3.3.1 Component Gain/Offset Adjustment
- Convert to Component in Input-source
- Signal equipment displays
Impress Resolution 720p
MODEL : 216
in Pattern Generator(720P/60Hz 100% Color
Bar Mode)
PATTERN : 65 in Pattern Generator( MSPG-925 SERISE)
Adjustment pattern (COMPONENT )
Copyright
LG Electronics. Inc. All right reserved.
Only for training and service purposes
- Adjust by commanding AUTO_COLOR_ADJUST.
4.3.3.2 Confirmation
- We confirm to address "0xF3 (offset), 0xF4 (gain)" in page
"0x0E" of EEPROM the value is "0xAA' or not.
- If the value is not "xAA", we adjust once more.
- We can write the ADC values from "0x06~0x0B" addresses
in a page "0x0E".
*Manual ADC process using Service Remocon. After enter
Service Mode by pushing "ADJ" key, execute "Auto-RGB" by
pushing "
" key at "Auto-RGB".
- 15 -
LGE Internal Use Only
Advertisement
