Table of Contents
Advertisement
13.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the
product and also at the end of each water intake hose where they are
connected to the tap. These filters prevent foreign substances and dirt in
the water to enter the product. Filters should be cleaned if they are dirty.
Washing Machine / User's Manual
a) Close the taps.
b) Remove the nuts of the water intake hoses to
access the filters on the water intake valves.
Clean them with an appropriate brush. If the
filters are too dirty, remove them from their
places with a pliers and clean in this way.
c) Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under running water.
d) Replace the gaskets and filters carefully in
their places and tighten the hose nuts by
hand.
EN / 49
Advertisement
Table of Contents
