Table of Contents
Advertisement
Installation
Exhaust ducting guide
Ducting
1. Make sure the dryer is installed properly so the air exhausts freely.
2. Use 4-inch rigid metal ducts. Tape all joints including the dryer connection. Never use lint-trapping
screws.
3. To facilitate the exhaust, keep the ducts as straight as possible.
Cleaning
Clean all old ducts before installing the dryer, and make sure the vent flap opens and closes freely. We
recommend that you to clean the exhaust system annually or on a regular basis.
WARNING
• To prevent fire, do not use plastic, thin-foil, or non-metal flexible ducts of any kind.
• Do not use a poor exhaust system because it slows down the dryer's performance.
• Do not use excessively long ducts that have multiple elbows.
• Do not use crushed or clogged venting or ducts.
Switching the door position
32
English
Untitled-30 32
To reverse the direction of the door, we recommend that
you contact a qualified technician.
1. Put a soft rug on the floor to rest the door on after
you have removed it. This will prevent the door from
being scratched.
2. Unplug the power cord of the dryer.
3. Remove the four hinge screws from the door, and
then remove the door by lifting it up slightly.
4. Remove the two screws from the lever holder, and
then remove the holder cover.
5. Put the lever holder on the other side as shown, and
then tighten the screws. Install the holder cover on
the opposite side as shown.
2023-06-28( )
3:08:46
Hide quick links:
Advertisement
Table of Contents
