Advertisement
Troubleshooting guide
PROBLEM
LED's not lighting up
PROBLEM
LED's not flashing in music
mode
LED color not synchronized to
the gauge
:
POSSIBLE CAUSE(S)
No power to the BIM-RGB
Poor connection on the +, R, G or B
outputs
BIM-RGB is in music mode
POSSIBLE CAUSE(S)
BIM-RGB is not in a location where the
microphone can pick up the music
The LED outputs are not turned on
Bad connection to the gauge
Sync mode not enable
POSSIBLE SOLUTIONS(S)
Check power and ground connections into the BIM_RGB
Check the connections to the LED's
In music mode the LED's will flash on with music. Go into the settings
and make sure music mode is off. If you tap on the BIM-RGB case by
the microphone input and the LED's flash this is most likely the
problem.
POSSIBLE SOLUTIONS(S)
Be sure the BIM-RGB is located where it can pick up sound from a
speaker. If you tap on the BIM-RGB case by the microphone input the
LED's should flash. If they do this is most likely the problem
Check the On/Off setting in the app, or toggle the On/Off switch if
using the optional switch panel. If you toggle the music mode switch
the LED's should turn on and off if no music is playing and the LED
outputs are turned on.
Check the cable between the gauge and BIM-RGB. If LED's are white
this is the default color and would indicate this may be the problem.
The module defaults to standalone mode if no message from the
gauge is detected after 10 seconds.
Check the synch setting in the app, or if using the optional switch
panel press the color switch for greater that 3 seconds to change
modes
9
MAN # 650810
Advertisement
