WaveWare WT 802 Programming Manual

WaveWare Technologies, Inc.
"Enhancing Mobile Alert Response"
Visit Our Website at:
www.WirelessMessaging.com
2630 National Dr. Garland TX. 75041 PH: 1.800.373.1466
Powered By Daviscomms
Part Number = WT-802
WT 802 Button Programming Guide
- - - The WaveWare WT 802 Alphanumeric Pager
- - - Button Programming Allows the Editing of the:
- - - Frequency: Between 450 - 470 MHz
- - - Cap Code(s): Up to 7 Cap Codes
- - - Baud Rate: 512, 1200 and 2400
- - - Password: Protection of the Configuration
- Before beginning, become Familiar with the Buttons...
- The Function Button (Red Dot), Part of its Function is...
- - Moves you to the Next Step / Screen
- - - Allowing the Viewing of Each Individual Screen
- The Read / On Button (Blue Dash), Part of its Function is...
- - Pressing this at anytime Exits Program Mode
- - - Returns you to the Version Screen
- The 4 Arrow Buttons (Up, Down, Backward and Forward)
- - Allows the Changing of the Location and Values of the Cursor
- To Start, be sure the Pager is TURNED-OFF
- - To do this, Press the Read / On Button (Blue Dash)
- - The Pager will Display "Pager Off"
- Remove "AA" Battery from the Pager
- - Refer to the User Manual
- Press and Hold the Function Button (Red Dot), and...
- - Press and Hold the Read / On Button (Blue Dash)
- - - Now, while Pressing the 2 Buttons, Re-Insert the "AA" Battery
- This will Place Pager into "Test Mode"