Sony IPELA SNC-RZ50N Install Manual page 50

qa m (microphone input) jack
(minijack, monaural)
Connect a commercially available
microphone. This jack supports plug-in-
power microphones (rated voltage: 2.5
V DC).
You can connect the microphones of the
following specifications to this camera.
Type: Electret condenser microphone
Plug-in power system
Directivity: Omni-directional
Sensitivity: –40 ± 3.5 dB
Frequency range: 50 – 15,000 Hz
Plug: ø3.5 Mini-plug
qs 5 (line output) jack (minijack,
monaural)
Connect a commercially available
speaker system with the built-in
amplifier.
You can connect the speakers of the
following specifications to this camera.
Type: Active speaker
Impedance: Input impedance 4.7 kohms
or more
Plug: ø3.5 Mini-plug
qd I/O (Input/Output) port
This port is provided with an RS-232C
port, two sensor inputs and two alarm
outputs.
The RS-232C port is used when you
connect peripheral devices to the camera
using the RS-232C interface, and control
the camera or transmit/receive data from
the devices.
The sensor input is used as the alarm
input. The camera operation can be
synchronized with e-mail (SMTP) or
other applications.
The alarm output is used to control
connected peripheral devices by
synchronizing with an external sensor
input, the built-in detection function, a
manual trigger button, Day/Night
function or the timer function.
For pin assignment and wiring, see "Pin
Assignment and Use of I/O Port" on
page 31.
12
GB
Location and Functions of Parts and Controls
Note
The I/O port of this unit corresponds to
the VISCA command. However, there
are some commands which are not
supported.
qf Reset switch
To reset the camera to the factory default
settings, supply the power to the camera,
while holding down this switch with a
pointed object.
For details on each function and required
settings, see the User's Guide stored in the
supplied CD-ROM.
Bottom
qg qh
qh
qg Tripod hole
Use this hole when attaching the camera
to a tripod (screw: 1/4", 20 UNC)
qj
U1/4", 20 UNC
= 4.5 mm ± 0.2 mm
(ISO standard)