Table of Contents
Advertisement
Operating tips
After the appliance has been switched
■
on, it may take several hours until
the set temperatures have been
reached.
Do not put any food in the appliance
beforehand.
While the refrigeration unit is running,
■
water droplets or a thin layer of ice
may form at the rear panel of
the refrigerator. This is nothing
unusual. It is not necessary to scrape
off the frost or wipe off the water
droplets. The rear panel defrosts
automatically. The condensation
collects in the drainage channel,
Fig. *, and is conveyed
to the refrigeration unit where it
evaporates.
The sides of the housing are
■
sometimes heated slightly. This
prevents condensation in the area
of the door seal.
If the freezer compartment door
■
cannot be immediately re-opened after
it has been closed, wait until
the resulting low pressure has
equalised.
The refrigeration system may cause
■
several areas of the freezer shelves
to frost quickly. This does not affect
function or power consumption.
The appliance does not require
defrosting until the entire surface
of the freezer shelf is covered with
more than 5 mm of frost or ice.
Setting the
temperature
Fig. "
Refrigerator compartment
The temperature can be set from +2 °C
to +8 °C.
Keep pressing temperature setting
button 4 until the required refrigerator
compartment temperature is set.
The value last selected is saved. The set
temperature is indicated on temperature
display 2.
Freezer compartment
The temperature in the freezer
compartment depends on
the temperature in the refrigerator
compartment.
Lower temperatures in the refrigerator
compartment also cause lower
temperatures in the freezer
compartment.
Usable capacity
Information on the usable capacity can
be found inside your appliance on
the rating plate. Fig. .
en
9
Advertisement
Table of Contents
