Installation Test (Duct Check) - LG DlGX5006 Series Owner's Manual

30
iNSTALLATiON

Installation Test (Duct Check)

Once you have completed the installation of the dryer,
use this test to make sure the condition of the exhaust
system is adequate for proper operation of the dryer.
This test should be performed to alert you to any serious
problems in the exhaust system of your home.
• Your dryer features Flow Sense
system that automatically detects blockages and
restrictions in dryer ductwork. Keeping ductwork clean
of lint buildup and free of restrictions allows clothes to
dry faster and reduces energy use.
NOTE
The dryer should be cool before starting this test. If
the dryer was warmed up during installation, run the
AIR DRY cycle for a few minutes to reduce the interior
temperature.
To activate the Installation test:
1. Remove the drying literature, and then close the
door.
Do not load anything in the drum for this test, as it
may affect the accuracy of the results.
2. After you are pressed of Power button, you will
press and hold the Temp. and Signal buttons in
0.5 seconds.
This button sequence activates the installation test.
The code will display if the activation is
successful.
3. Press the Hold to Start button.
The dryer will start the test, which will last about
two minutes. The heat will be turned on and the
temperatures in the drum will be measured.
TM
, an innovative sensing
4. Check the display for results.
During the test cycle, monitor the Flow Sense
display on the control panel. If the Flow Sense
indicator text lights up, the exhaust system is
restricted. If the indicator text remains dark, the
exhaust system is adequate.
Other problems may also be shown with error codes.
Refer to the next page for error code details and
solutions.
DARK:
OK
Have the system checked immediately, as performance
will be poor.
5. End of cycle.
At the end of the test cycle,
The test cycle will end and the dryer will shut off
automatically after a short delay.
TM
LIGHTED:
RESTRICTED
will display.