Table of Contents
Advertisement
How to use the robot vacuum cleaner
Installation of the robot vacuum cleaner
1. Place the Charging base on the floor against the
wall. Plug the adaptor to the power jack on the
bottom of the base. Connect the Power cord plug to
the main socket. Wind up excessive cord on the back
of the base. Make sure there is an empty area of 0.5
m on the sides and 1.5 m in front of the Charging
base.
Note: Place the base in range of the WiFi router.
2. Attach the side brushes.
Note: If the robot is used to clean rooms with wall-to-
wall carpet, remove the side brushes for best cleaning
results.
3. Place the robot on the charging base.
The buttons will flash to indicate that the
robot is recharging.
Preparing the mopping function
1. Attach the mopping cover.
Attach the mopping pad with the cover and place
the mopping cover on the bottom of the robot.
Note: Only be done when mopping is to be
performed- i.e. not when vacuuming carpets.
www.electrolux.com
0.5m
0.5m
1.5m
3
Advertisement
Table of Contents
